Learn how to properly clean your UTV’s CVT drive belt
| How To Wash A CVT Belt: |
|---|
| In a clean sink, get the water warm then run the belt under it. |
| Put a spoon full of grease fighting liquid dish soap onto new green Scotchbrite pad. |
| Throughly scrub underneath, the top and both sides of your belt. |
| This removes any construction, cutting or shipping oils that may be on the belt. |
| Completely rinse the belt so all the soap is washed away. |
| Let the belt air dry before installation. |
| Use compressed air to clean both clutches. |
| Wipe them free of dust. |
| Take a new green Scotchbrite pad and lightly etch both halves of each clutch. |
| Make sure you get inside the driven clutch as deep as you can. |
| Pour a tablespoon worth of denatured Alcohol on a clean paper towel. |
| Wipe the clutch halves clean then install your washed belt. |
/cloudfront-us-east-1.images.arcpublishing.com/octane/JMJKUGKQCZGRZIVZBOKD3XPHZA.jpg)
/cloudfront-us-east-1.images.arcpublishing.com/octane/EG5G2TRRWRHDJAZR2DEXFYFZHU.jpg)
